SLIC SPECIAL FUNCTION DISPLAY UNITS - Specification
(Units can contain a selection of the following specifications)
Supply
110/230V ac plus a selection of dc supplies
Consumption
3VA
Sensor Supply
24V dc output available when mains powered.
Reverse & short circuit protected.
Input
6 circuits, referenced to 24V dc supply.
2 optionally connected to a quadrature decoder,
Fast/slow response selectable (common control),
pnp/npn selectable (common control),
ESD protected
Outputs
4 x N/O relay contacts rated @ 5A ac non-inductive
Keyboard
Membrane, 14 keys, 0-9, Reset, Total, Set1 & Set2
General
Power fail detection with battery back-up, sufficient for at least 1 month
Connection
Plug-in screw terminals on rear of unit
Protection
IP41
Weight
530g

Applications: (typical).

Spray Control System
 The object is to spray each item using guns 1-4 as appropriate, wasting as little paint as possible.
Items are detected by photo-cells which must be mounted outside the spray booth and the SLIC records the number of encoder pulses for which the item is detected. This information transfers into a shift register which tracks the item from the photocell to the spray guns to spray the object. Facilities are incorporated to over or underspray the object if necessary.
SLIC application from Synatel


Gyro Test Unit
 The turbine is run upto a specific speed of 1400 RPM and then allowed to free wheel.
The unit diplays speed and when the speed falls to 1100 RPM it switches to display lapsed time. When the speed falls to 800 RPM the time is displayed until the next test sequence. An RS232 output is provided for analysis by computer.

SLIC application from Synatel

Saw Angle Controller
 The SLIC displays the angular position of the saw and provides an output to apply a brake at one of four preset settings.
The presets are set on the SLIC which displays to an accuracy of 0.1. An adjustable dead band can be incorporated. the reset, resets the display to 90.0 which the reads + or - zero to 90.0 dependent upon direction of rotation. The display is scaleable to suit any encoder.
SLIC application from Synatel



© SYNATEL


This is one page of our multi-page website. If you have landed here by accident click on the 'SYNATEL' logo above to view our full site. e&oe.

Synatel:
Design, manufacture & sell a range of sensors aimed at solving detection problems within the day to day working environment.
Photoelectric sensors: retro-reflex, reflex and through beam versions.
Proximity sensors: both inductive and capacitive.
Speed monitors: inductive sensor based, monitoring rotating or reciprocating equipment and providing a signal at stop, under or over speed.
Digital diplay: used for counting, batching routing or speed indication, control applications.
Level controls: capacitance or inductive level sensors ideal for liquids, powders or granular solids.

Our manufacturing facility also enables us to offer a full bespoke design and manufacturing service, if required.